34251. The hottest part of the flame lies in its____zone.
34252. Bunsen burner is an example of a/an __________ burner.
34253. Higher efficiency in the combustion of solid fuel can not be achieved by
34254. A coal containing very high percentage of durain is called __________ coal.
34255. During combustion of gaseous fuels, deficiency of air
34256. Gross and net calorific value of a fuel will be the same
34257. Low temperature carbonisation
34258. Example of an indirectly heated furnace is
34259. Which furnace employs preheating, heating and soaking zones ?
34260. Calcination of limestone to produce lime is done in a __________ kiln.
34261. Thickness of stock does not affect the fuel economy of furnaces, if the material to be heated is of
34262. Ceramic recuperators compared to metallic recuperators for the same duty
34263. In order to maintain a reducing atmosphere in a furnace, it should have
34264. Which is the most thermally efficient furnace ?
34265. The heat recoverable from flue gases of furnaces depends on the
34266. Ceramic recuperators (made of SiC) is economical, only when used for preheating combustion air above __________ °C.
34267. Which is a continuous furnace ?
34268. Which of the following is the most suitable for preheating combustion air above 650°C ?
34269. Soaking pits are meant for heating steel
34270. The purpose of controlling the furnace atmosphere is to prevent surface attack by
34271. Thermal efficiency of a limestone calcination rotary kiln may be around __________ percent.
34272. In producer gas making furnace, steam is added along with air to mainly control the
34273. Fuel used in B.F. stove is
34274. Tunnel kilns are usually used for
34275. The thermal efficiency of a steel slab reheating furnace (walking beam type) may be about __________ percent.
34276. Higher furnace temperature can not be achieved by use of a lean fuel gas in the furnace by
34277. Temperature of a furnace fired with low calorific value fuel gas (i.e. lean gas) can be increased by
34278. Ceramic coating material for furnace refractory, which increases its emissivity and thus the radiation heat transfer rate in the furnace, comprises of
34279. In reverberatory furnace, charge is heated mainly by
34280. An example of a periodic furnace is the
34281. Ostwald charts are meant for
34282. Maximum heat transfer in high temperature furnaces is by
34283. Which of the following is a natural draft furnace ?
34284. To reduce the stack loss, heat recovery from flue gas can be done by
34285. Large tonnage of refractory bricks are dried in a
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use