1. In a shaft, the shear stress is not directly proportional to





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A sliding mesh gearbox has a gear ratio 4:1 at the third gear position. The clutch shaft gear has 15 teeth and its mating lay shaft gear is having 45 teeth. If the main shaft gear contains 28 teeth, the mating lay shaft gear should have:....
QA->Which transmission unit is used to turn the driven shaft faster than the driving shaft?....
QA->Compensative errors of length L is proportional to :....
QA->Upon which development the Second Five Year Plan laid mote stress?....
QA->On which thing did the Buddhism and Jainism both give stress?....
MCQ->The maximum shear stress in a solid shaft of circular cross-section having diameter d subjected to a torque T is τ. If the torque is increased by four times and the diameter of the shaft is increased by two times, the maximum shear stress in the shaft will be....
MCQ->Consider the following statements :In a uni-dimensional stress system, the principal plane is defined as one on which the 1. shear stress is zero. 2. normal stress is zero.3. shear stress is maximum. 4. normal stress is maximum. Of these statements :....
MCQ->Consider the following statements :1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area.2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum.3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum.Of these statements :....
MCQ->The average shear stress in the hollow shaft is smaller than the average shear stress in the solid shaft.....
MCQ->The maximum shear stress developed on, the surface of a solid circular shaft under pure torsion is 320 MPa. If the shaft diameter is doubled, then the maximum shear stress developed corresponds to the same torque will be :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions