Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in 049
Multiple Choice Question in
Multiple Choice Question in 2016
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. A control rod
(A): should have small absorption cross-section.
(B): is generally made of boron, hafnium or cadmium.
(C): should have large absorption cross-section.
(D): both and .
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->The Regulating Act was passed, bringing the company partially under Parliament’s control and the Presidencies under Calcutta’s control.....
QA->Golden Rod is the National Emblom of....
QA->Rod Shaped bacteria are known as?....
QA->The solution of nickel sulphate in which nickel rod is dipped is diluted 10 times. The potential of nickel:....
QA->When an ebonite rod is rubbed with fur; which charge acquired by the fur?....
MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be....
MCQ->A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 x 106 kg/cm2, the side of the rod, is....
MCQ->A steel rod, 100 mm long is held between two rigid supports. It is heated by 20°C. If the coefficient of thermal expansion of the material of the rod is 15 x 10-6 /° C and modulus of elasticity is 200 x 103 MN/m2, what is the stress in the rod ?....
MCQ->A rod shown in the given figure is such that the lower part is made of steel and the upper part is made of copper. Both the ends of the rod are rigidly clamped. If an axial force P is applied at the junction of the two metals, given that the ratio Esteel/ECopper is equal to 2, then the force in the copper rod would be....
MCQ->A horizontal rod AB carries three loads of 3.0 kg, 7.0 kg and 10.0 kg at distances of 2.0 cm, 9.0 cm and 15 cm respectively from A where it is hinged. Neglecting the weight of the rod, which is the point at which the rod will be balance ?....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions