1. The materials used for cylinder block are





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Cylinder block construction by mono-block is preferred to individual cylinder construction because of?....
QA->A loose fit between a dry cylinder liner and cylinder block would cause:....
QA->A computer has 8 MB in main memory, 128 KB cache with block size of 4KB. If direct mapping scheme is used, how many different main memory blocks can map into a given physical cache block?....
QA->Which is not an advantage of multi cylinder air cooled engines when compared to multi cylinder water cooled engines?....
QA->A groupof scientists recently discovered two materials that are capable of resistingtemperatures of nearly 4000 degrees Celsius.These two materials are....
MCQ->What is the volume of the cylinder (in cubic metre)? (I) The sum of height and radius of the cylinder is 24m. The total surface area of the cylinder is 2112 sq. m. (II) LCM and HCF of the numerical values of the radius and height of the cylinder are 70 and 2 respectively. The square of numerical values of the radius of the cylinder is 96 more than the square of the numerical value of the height of the cylinder.....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
MCQ->In cases of emergency, the gas actuator can be used to move a 75-kg block B by exploding a charge C near a pressurized cylinder of negligible mass. As a result of the explosion, the cylinder fractures and the released gas forces the front part ofthe cylinder, A, to move B and the floor is = 0.5, determine the impulse that the actuator must impart to B.....
MCQ->A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?....
MCQ->A compound cylinder with inner radius 50 mm and outer radius 70 mm is made by shrinking one cylinder on to the other cylinder, The junction radius is 60 mm and the junction pressure is 1.1 N/mm2. The maximum hoop stress developed in the inner cylinder is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions