39151. Bottom of basic open hearth furnace are constructed of
39152. Which form of silica has the highest specific gravity ?
39153. Ceramic recuperators used for waste heat recovery from high temperature flue gas going out of the furnace is made of
39154. __________ is the measure of the strength of refractory under the combined effect of temperature & load.
39155. National Statistical Day is observed on
39156. The Vernacular Press Act of 1878 was introduced by
39157. Lower wall courses of soaking pits are made of __________ bricks to avoid the action of molten slag & scale.
39158. Addition of grog in fireclay brick during its manufacture is advantageous, because it results in
39159. Slide gates in teeming laddie used for steel pouring in ingot moulds is lined with __________ bricks.
39160. Fireclay refractories
39161. Addition of zircon to silica refractory brick improves its
39162. Which is a neutral refractory ?
39163. Permeability of bricks is a measure of the
39164. With increase in the density of silica refractories, its
39165. Magnesite chrome refractories
39166. Fireclay bricks is not used for lining the
39167. Pure bauxite is the best raw material for the manufacture of high alumina refractories, in which maximum alumina content can be as high as __________ percent.
39168. Refractoriness under loads (RUL) is quite close to the fusion temperature (PCE) for __________ bricks.
39169. Refractories subjected to alternate cycles of heating & cooling are liable to loose their resistance to
39170. Thermal spalling mainly occurs during __________ of furnaces.
39171. An ideal refractory should have high
39172. Ganister is a source of the
39173. Which brick undergoes maximum shrinkage on drying ?
39174. Which is the stable form of silica upto 1470°C ?
39175. Hot face insulating linings of high purity alumina fused mullite are used, where
39176. Semi-silica bricks compared to silica bricks have
39177. Mixing of ground refractory material and water is done in a __________ mill.
39178. Maximum apparent porosity of magnesite bricks is about __________ percent.
39179. Dilatometer is used for the determination of __________ of refractories.
39180. With decrease in porosity, the __________ of the refractories decreases.
39181. Porosity of silica bricks varies from __________ percent.
39182. Colour of fireclay bricks is
39183. Rate of slag attack on refractories increases with rise in temperature due to the
39184. Which of the following is not a high alumina refractory material ?
39185. Magnesite chrome bricks are used in the
39186. Mullite is chemically represented by
39187. __________ bricks are used in the burning zone of a cement rotary kiln.
39188. Furnace atmosphere for softening temperature determination of refractories (in which segar cones are placed) should be
39189. Roof of a basic open hearth furnace is lined with __________ bricks.
39190. High alumina refractories are used in the
39191. Maximum shrinkage in volume occurring during burning/firing of dried refractories may be as high as __________ percent.
39192. Porosity of fireclay refractories is __________ percent.
39193. SiO2 percentage in firebrick is about
39194. Porosity is induced in insulating refractories by adding
39195. Magnesite bricks have poor resistance to attack by __________ slag.
39196. Zirconia refractories are not used in
39197. Carbon refractories
39198. Magnesite refractories have low resistance to
39199. Which property is important for bricks used in the combustion chamber & dome of blast furnace stoves ?
39200. The maximum linear expansion of silica bricks during firing is about __________ percent.
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use