<<= Back Next =>>
You Are On Multi Choice Question Bank SET 959

47951. On the PC side, the printer port is a:






47952. You were installing an application in Windows 95, and the computer crashes, what do you do?






47953. RS-232 is a standard that applies to:






47954. You just installed a new IDE hard drive, but your system BIOS will not recognize the new drive, what should you check first.






47955. During boot-up, the memory test:






47956. What is the best ground for a conductive work bench?






47957. Topically, how many type III PC cards can you insert in a laptop






47958. What is the first thing you could do to check for damage to a printer after receiving it?






47959. You have a system that periodically locks up. You have ruled out software, and now suspect that it is hardware. What should you do first that could help you narrow it down to the component at fault?






47960. What's the best way to protect your hard drive data?






47961. On a dot matrix printer, you should never lubricate which part?






47962. How many devices can be used on a single SCSI bus? Keep in mind that the SCSI host adapter counts as a device.






47963. Match the device driver HIMEM.SYS to its operation.






47964. _____ help prevent power surges.






47965. The digital multimeter is set for DC, Ohm and 20k. You will read _____ while measuring a good 2 amp fuse.






47966. An anti static strap uses a small _____ to make sure you do not become the least path of resistance to the ground?






47967. If the memory slots have 30 pins then the chip is a?






47968. Laser Jet printer speeds are measured in pages per minute (ppm) what do we use to measure dot-matrix printers?






47969. Which values are held in CMOS for the hard drive






47970. Which of the following would be a logical first step in troubleshooting a PC?






47971. Which DOS driver is used to emulate expanded memory?






47972. For a Macintosh to print successfully, the System Folder must contain:






47973. Which component must be vacuumed or replaced during preventative maintenance on a laser printer?






47974. Which device uses a DMA channel?






47975. When is the risk for electrostatic discharge the greatest?






47976. A modem could be attached to which port?






47977. What device prevents power interruptions, resulting in corrupted data?






47978. SCSI must be terminated with?






47979. In a computer with an eide adapter, where should you connect an ATA CD-ROM drive?






47980. What's the best way to prevent damaging your PC with static electricity?





47981. IRQ6 is typically reserved for:






47982. Which would you do first when troubleshooting a faulty monitor?






47983. To install a second IDE drive into a computer, you must:






47984. Why does a successfully mapped network drive disappear every time you boot the computer?





47985. What do you need to check serial and parallel port?






47986. You have a PC with no video Which of the following is LEAST likely to be causing the problem?






47987. To test for AC ripple on a PC power supply, you would set the volt/ohm meter for:






47988. You get a CMOS checksum error during bootup. What is most likely the cause?






47989. When measuring AC (Alternating Current) with a multimeter, it is important to maintain the proper polarity.



47990. After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?






47991. What is a common language that computers use to talk with one another on a network






47992. Which should you use for cleaning Mylar-protected LCD screens?






47993. What could cause a fixed disk error?






47994. ESD potential decreases with the use of:






47995. Which of the following FRUs would be considered both an input/output device?






47996. A COM port is a _____ port.






47997. Which device is on IRQ 6?






47998. A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?






47999. What is the most significant difference between the USB and IEEE1394 standards?






48000. When connecting two internal SCSI hard disks to a computer, where do you connect the second hard drive?






<<= Back Next =>>
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions