Multi Option Question Page 893

<<= Back Next =>>

You Are On Multi Choice Question Bank SET 893

44651. A symmetrical channel section is made of a material which is equally strong in tension and compression. It is used as a simply supported beam with its web horizontal to carry vertical loads. It will

44652. A machine costing Rs. 8, 500 will have a scrap value of Rs. 300. Machines of this class have a working hour average life of 25, 000 hours. What will be the depreciation charge at the end of the first year, if the machine is operated for a total of 1500 hours ? (use straight line method of depreciation)

44653. The limits of percentage p of the longitudinal reinforcement in a column is

44654. Figure shows the forces acting on a body. Each square is 3 cm x 3 cm. If F1 = 30 N, F2 = 15 N, F3 = 25 N and F4 = 20 N, the resultant force and the moment about point O, respectively, are

44655. A simply supported beam of span (l) carries a point load W at midspan. The breadth 'b' of the beam along the entire span is constant. Given, f = permissible stress in bending, for a beam of uniform strength, the depth of the beam at any cross-section, at a distance x from the support would be :

44656. In the truss shown in the given figure which one of the following members has no force induced in it ?

44657. Consider the following statements :A : An isotropic material is always homogeneous. R : An isotropic material is one in which all the properties are the same in all the directionsat every point.Of these statements :

44658. The ratio of pressures between two points A and B located respectively at depths 0.5 m, and 2 m below a constant level of water in a tank is

44659. The acceleration of a particle starting from rest varies with time according to the relation a = - sω2 sin ωtWhat is the displacement of this particle at a time t ?

44660. For which one of the following purposes is the double mass curve used ?

44661. If s is the shear strength, c and Φ are shear strength parameters, and σn is the normal stress at failure, then Coulomb's equation for shear strength of the soil can be represented by

44662. The beam shown in the figure given above is subjected to concentrated load and clockwise couple. What is the vertical reaction at A ?

44663. If all the dimensions of a prismatic bar of square cross-section suspended freely from the ceiling of a roof are doubled then the total elongation produced by its own weight will increase

44664. Which of the following statements are true for the pile shown in the figure ?1. Frictional resistance acts upwards through the length of the pile.2. Negative skin friction acts over the length AB3. Frictional resistance acts upwards over the length BC4. There is point resistance at level CSelect the correct answer using the codes given below :

44665. If the standard meridian is 82°30' E and the standard time at longitude 90°E is known to be 8 hr 30 m, the corresponding local mean time at the place will be

44666. For a masonry dam of base width b, at which location w.r.t. the central line, should the resultant loading intersect the section to avoid tension in any horizontal section ?

44667. Consider the following statements :Excessive camber is not provided on the roads because1. Transverse tilt causes uncomfort2. Of formation of cross ruts3. Of likely toppling over of highly laden bullock carts4. Of higher costs involvedWhich of the statements given above are correct ?

44668. Consider the following statements :1. A project has a mission.2. A project has to terminate at some time or the other.3. Projects vary in terms of technology, equipment and materials, machinery and people, work ethics and organisational culture.Amongst the above, the characteristic features for a project are

44669. Which one of the following gives the correct distance between the lighthouse and a ship, when the lighthouse whose height is 100 m is visible just above the horizon from the ship ?

44670. Consider the following statements :Bearing stiffness, in plate girders, are :1. provided at supports.2. provided under concentrated loads.3. provided alternately on the web.Which of the statements given above is/are correct ?

44671. Which one of the following statements is correct ?As the depth of immersion of a vertical plane surface increases, the location of centre of pressure.

44672. A highly sensitive undisturbed clay sample was brought to the laboratory and UU test was performed. The curve of deviator stress versus strain % plot will be (among the four curves shown in the given figure) the one labelled

44673. The sequent depth ratio in a hydraulic jump formed in a horizontal rectangular channel is 16.48. The flow is supercritical. What is the value of the Froude number of flow ?

44674. Consider the following operations in a spire test :1. Depress telescope and sight a point on the ground nearer to the instrument2. Clamp horizontal plates3. Sight a well defined high point on a high building4. Change face and repeat the procedure.The correct sequence of these operations is

44675. Probability of a lO-year flood to occur at least once in the next 4 years is

44676. Weigh-batching proceeds on

44677. A cantilever beam of span l carries a uniformly varying load of zero intensity at the free end and w per metre length at the fixed end. What does the integration of the ordinate of the load diagram between the limits of free and fixed ends of the beam give ?

44678. A shaft PQRS is subjected to torques at P, Q, R, S as shown in the given figure.The maximum torque for the shaft section occurs between

44679. When the recirculation ratio in a high rate trickling filter is unity, then what is the value of the recirculation factor ?

44680. In a direct shear test the shear stress and normal stress on a dry sand sample at failure are 0.6 kg/cm2 and 1 kg/cm2 respectively. The angle of internal friction of the sand will be nearly

44681. In the network given in figure, the maximum number of shovels and dumpers required are

44682. Consider the following statements :A good soil for making bricks should contain1. about 30% alumina 2. about 10% lime nodules 3. a small quantity of iron oxides 4. about 15% magnesia.Of these statements :

44683. Service connection consists of

44684. What does super-saturation of water body with DO cause ?

44685. In a third order traverse, if the standard error of ± 3" is assigned to each of the four source of errors, namely :(i) reading the vernie(ii) non-adjustment of transit(iii) sighting and(iv) setting over the station, then the total standard error of the work would be

44686. Fluid moves in a direction opposite to the sedimentation movement:

44687. Consider the following statements regarding settlement of foundations :1. Differential settlement of foundation leads to structural damage to the superstructure.2. In non-cohesive soils, the major component of settlement is due to consolidation.3. Lowering of ground water table contributes of settlement of foundations.Of these statements :

44688. A solid circular shaft is subjected to a bending moment M and torque T. The ratio of maximum bending stress to the maximum shear stress is given by

44689. Which one of the following closely represents the shape of the earth?

44690. Based on the Gaussian law of distribution of random errors, the number of errors that are expected to exceed the limit of ± a, where 0 represents the standard deviation, out of 1000 observations is

44691. In a trigonometric levelling, the height of the signal used is 4.62 m and the instrument height is 1.25 m. If the horizontal distance of the target from the instrument is 5780 m, then the axis-signal correction is

44692. Coulter current method used for determination of:

44693. The rotation of a rigid body is governed by What is its angular velocity at t - 2s ?

44694. Drug used for ulcerative colitis:

44695. The figure shows a rigid frame fixed at A and hinged at C.If a pure moment of 20 kNm is applied at B in the plane of the figure, then what is the moment at the fixed end A?

44696. A moderately sedative antid histamine:

44697. The effective throat thickness in mm of a 6 mm size fillet weld with an angle of 75° between the fusion faces is

44698. Avicel is the trade name of

44699. Which one of the following is the correct statement ? A streamlined body is one for which the

44700. An oral hypoglyceamic sulphonyl urea drug:

<<= Back Next =>> Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use

44651. A symmetrical channel section is made of a material which is equally strong in tension and compression. It is used as a simply supported beam with its web horizontal to carry vertical loads. It will (adsbygoogle = window.adsbygoogle || []).push({});