The ALU of a central processing unit does the essential maths work for the computer. What does the control unit do? ?->(Show Answer!)

1. The ALU of a central processing unit does the essential maths work for the computer. What does the control unit do?

Write Comment

Comments

Tags

Show Similar Question And Answers

QA->The function of Arithmetic and Logic Unit (ALU) is?....

QA->Anil can do a work in 12 days. Basheer can do it in 15 days. Chandran can do the same work in 20 days. If they all work together, the number of days need to complete the work is :....

QA->What are the main parts of central processing unit?....

QA->Liz solved 24 maths problems in 15 minutes.At this rate,how many problems can she solve in 40 minutes?....

QA->Computer processing speed is measured in terms....

MCQ-> A distinction should be made between work and occupation. Work implies necessity; it is something that must be done as contributing to the means of life in general and to one.s own subsistence in particular. Occupation absorbs time and energy so long as we choose to give them; it demands constant initiative, and it is its own reward. For the average person the element of necessity in work is valuable, for he is saved the mental stress involved in devising outlets for his energy. Work has for him obvious utility, and it bring the satisfaction of tangible rewards. Where as occupation is an end in itself, and we therefore demand that it shall be agreeable, work is usually the means to other ends . ends which present themselves to the mind as sufficiently important to compensate for any disagreeableness in the means. There are forms of work, of course, which since external compulsion is reduced to a minimum, are hardly to be differentiated from occupation. The artist, the imaginative writer, the scientist, the social worker, for instance, find their pleasure in the constant spontaneous exercise o creative energy and the essential reward of their work is in the doing of it. In all work performed by a suitable agent there must be a pleasurable element, and the greater the amount of pleasure that can be associated with work, the better. But for most people the pleasure of occupation needs the addition of the necessity provided in work. It is better for them to follow a path of employment marked out for them than to have to find their own.When, therefore, we look ahead to the situation likely to be produced by the continued rapid extension of machine production, we should think not so much about providing occupation for leisure as about limiting the amount of leisure to that which can be profitably usedWe shall have to put the emphasis on the work . providing rather than the goods. providing aspect of the economic process. In the earlier and more ruthless days of capitalism the duty of the economic system to provide work was overlooked The purpose of competitive enterprise was to realize a profit. When profit ceased or was curtailed, production also ceased or was curtailed Thus the workers, who were regarded as units of labour forming part of the costs of production, were taken on when required and dismissed when not required They hardly thought of demanding work as a right. And so long as British manufacturers had their eyes mainly on the markets awaiting them abroad, they could conveniently neglect the fact that since workers are also consumers, unemployment at home means loss of trade. Moral considerations did not yet find a substitute in ordinary business prudence. The labour movements arose largely as a revolt against the conception of workers as commodities to be bought and sold without regard to their needs as human beings. In a socialist system it is assumed that they will be treated with genuine consideration, for, the making of profit not being essential, central planning will not only adjust the factors of production to the best advantage but will secure regularity of employment. But has the socialist thought about what he would do if owing to technological advance, the amount of human labour were catastrophically reduced? So far as I know, he has no plan beyond drastically lining the hours of work, and sharing out as much work as there may be. And, of course, he would grant monetary relief to those who were actually unemployed But has he considered what would be the moral effect of life imagined as possible in the highly mechanized state of future? Has he thought of the possibility of bands of unemployed and under-employed workers marching on the capital to demand not income (which they will have but work?Future, according to the passage, may find the workers
....

MCQ->The ALU of a central processing unit does the essential maths work for the computer. What does the control unit do?....

MCQ-> Study the following information carefully to answer these questions.Seven friends P, Q, R, S, T, U and V are teaching subjects Maths, Physics, Biology, English, History, Psychology and French not necessarily in the same order. Each one of them has liking for a different colour Pink, Green, Blue, Red, Yellow; White and Orange again not necessarily in the same order. T teaches Biology and likes Green colour. Q teaches History and he does not like Yellow or Orange: The one who likes Red teaches physics. P teaches French and likes Blue: The one who teaches English likes Pink. R teaches Maths and V teaches psychology. U does not like Red: Maths teacher does not like Yellow.Which colour is liked by V?
....

MCQ-> In a modern computer, electronic and magnetic storage technologies play complementary roles. Electronic memory chips are fast but volatile (their contents are lost when the computer is unplugged). Magnetic tapes and hard disks are slower, but have the advantage that they are non-volatile, so that they can be used to store software and documents even when the power is off.In laboratories around the world, however, researchers are hoping to achieve the best of both worlds. They are trying to build magnetic memory chips that could be used in place of today’s electronics. These magnetic memories would be nonvolatile; but they would also he faster, would consume less power, and would be able to stand up to hazardous environments more easily. Such chips would have obvious applications in storage cards for digital cameras and music- players; they would enable handheld and laptop computers to boot up more quickly and to operate for longer; they would allow desktop computers to run faster; they would doubtless have military and space-faring advantages too. But although the theory behind them looks solid, there are tricky practical problems and need to be overcome.Two different approaches, based on different magnetic phenomena, are being pursued. The first, being investigated by Gary Prinz and his colleagues at the Naval Research Laboratory (NRL) in Washington, D.c), exploits the fact that the electrical resistance of some materials changes in the presence of magnetic field— a phenomenon known as magneto- resistance. For some multi-layered materials this effect is particularly powerful and is, accordingly, called “giant” magneto-resistance (GMR). Since 1997, the exploitation of GMR has made cheap multi-gigabyte hard disks commonplace. The magnetic orientations of the magnetised spots on the surface of a spinning disk are detected by measuring the changes they induce in the resistance of a tiny sensor. This technique is so sensitive that it means the spots can be made smaller and packed closer together than was previously possible, thus increasing the capacity and reducing the size and cost of a disk drive. Dr. Prinz and his colleagues are now exploiting the same phenomenon on the surface of memory chips, rather spinning disks. In a conventional memory chip, each binary digit (bit) of data is represented using a capacitor-reservoir of electrical charge that is either empty or fill -to represent a zero or a one. In the NRL’s magnetic design, by contrast, each bit is stored in a magnetic element in the form of a vertical pillar of magnetisable material. A matrix of wires passing above and below the elements allows each to be magnetised, either clockwise or anti-clockwise, to represent zero or one. Another set of wires allows current to pass through any particular element. By measuring an element’s resistance you can determine its magnetic orientation, and hence whether it is storing a zero or a one. Since the elements retain their magnetic orientation even when the power is off, the result is non-volatile memory. Unlike the elements of an electronic memory, a magnetic memory’s elements are not easily disrupted by radiation. And compared with electronic memories, whose capacitors need constant topping up, magnetic memories are simpler and consume less power. The NRL researchers plan to commercialise their device through a company called Non-V olatile Electronics, which recently began work on the necessary processing and fabrication techniques. But it will be some years before the first chips roll off the production line.Most attention in the field in focused on an alternative approach based on magnetic tunnel-junctions (MTJs), which are being investigated by researchers at chipmakers such as IBM, Motorola, Siemens and Hewlett-Packard. IBM’s research team, led by Stuart Parkin, has already created a 500-element working prototype that operates at 20 times the speed of conventional memory chips and consumes 1% of the power. Each element consists of a sandwich of two layers of magnetisable material separated by a barrier of aluminium oxide just four or five atoms thick. The polarisation of lower magnetisable layer is fixed in one direction, but that of the upper layer can be set (again, by passing a current through a matrix of control wires) either to the left or to the right, to store a zero or a one. The polarisations of the two layers are then either the same or opposite directions.Although the aluminum-oxide barrier is an electrical insulator, it is so thin that electrons are able to jump across it via a quantum-mechanical effect called tunnelling. It turns out that such tunnelling is easier when the two magnetic layers are polarised in the same direction than when they are polarised in opposite directions. So, by measuring the current that flows through the sandwich, it is possible to determine the alignment of the topmost layer, and hence whether it is storing a zero or a one.To build a full-scale memory chip based on MTJs is, however, no easy matter. According to Paulo Freitas, an expert on chip manufacturing at the Technical University of Lisbon, magnetic memory elements will have to become far smaller and more reliable than current prototypes if they are to compete with electronic memory. At the same time, they will have to be sensitive enough to respond when the appropriate wires in the control matrix are switched on, but not so sensitive that they respond when a neighbouring elements is changed. Despite these difficulties, the general consensus is that MTJs are the more promising ideas. Dr. Parkin says his group evaluated the GMR approach and decided not to pursue it, despite the fact that IBM pioneered GMR in hard disks. Dr. Prinz, however, contends that his plan will eventually offer higher storage densities and lower production costs.Not content with shaking up the multi-billion-dollar market for computer memory, some researchers have even more ambitious plans for magnetic computing. In a paper published last month in Science, Russell Cowburn and Mark Well and of Cambridge University outlined research that could form the basis of a magnetic microprocessor — a chip capable of manipulating (rather than merely storing) information magnetically. In place of conducting wires, a magnetic processor would have rows of magnetic dots, each of which could be polarised in one of two directions. Individual bits of information would travel down the rows as magnetic pulses, changing the orientation of the dots as they went. Dr. Cowbum and Dr. Welland have demonstrated how a logic gate (the basic element of a microprocessor) could work in such a scheme. In their experiment, they fed a signal in at one end of the chain of dots and used a second signal to control whether it propagated along the chain.It is, admittedly, a long way from a single logic gate to a full microprocessor, but this was true also when the transistor was first invented. Dr. Cowburn, who is now searching for backers to help commercialise the technology, says he believes it will be at least ten years before the first magnetic microprocessor is constructed. But other researchers in the field agree that such a chip, is the next logical step. Dr. Prinz says that once magnetic memory is sorted out “the target is to go after the logic circuits.” Whether all-magnetic computers will ever be able to compete with other contenders that are jostling to knock electronics off its perch — such as optical, biological and quantum computing — remains to be seen. Dr. Cowburn suggests that the future lies with hybrid machines that use different technologies. But computing with magnetism evidently has an attraction all its own.In developing magnetic memory chips to replace the electronic ones, two alternative research paths are being pursued. These are approaches based on:
....

MCQ-> This data is regarding total number of employees working in Administration (Admin), Operations (Ops.) and other departments of corporate divisions of Companies A and B The total number of employees working in both the companies together is 4800. The respective ratio of number of employees in Companies A and B is 5 : 7. Each employee works in only one of the mentioned departments. In company A, 70% of the total employees are males. 60% of the total male employees work in ‘Ops’. Out of the remaining male employees, $${{{1^{th}}} \over 8}$$ work in ‘Admin’. Out of the total female employees, 24% work in ‘Admin’ and$$ {{{5^{th}}} \over 8}$$ of the remaining female employees work in ‘Ops’. In company B, 80% of the total employees are males. 65% of the total male employees work in ‘Ops’. Number of male employees who work in ‘other departments’ in Company B is 20% more than the male employees who work in ‘Other departments in company A. Number of female employees who work in Ops in Company B are less than the number of male employees who work for ‘Ops’ in the same company, by 75%. Out of the remaining female employees,$$ {1 \over 4} $$work in ‘Admin’.What percent of the total number of male employees in company A work in ‘other departments’ ?
....